2x HB3 HB4 12V 50W 6 Ohm CAN-Bus lighting error resistance Power resistor SET
- Part no.:
- Delivery time:
- Available, 1-2 days shipping time
LICHTEX HB3 HB4 lamp failure control CANBUS 50W resistor
On-board computer lighting error
If the on-board computer reports an error when the vehicle is switched on,
is caused by installation of low power consumers(LED / SMD bulbs),
since the consumption e.g. was reduced from 55W to 15W.
Resistance control - equalizes voltage and corrects errors in on-board computer.
Only for vehicles with light test (lamp control) by on-board computer.
You just close resistance(Plug&Play-System), and the mistake is gone.
2x pieces in a set
There is no rating or review available.