12V 55W 3.5 Ohm CAN-Bus lighting error resistance Power resistor SET
- Part no.:
- Delivery time:
- Available, 1-2 days shipping time
LICHTEX lamp failure control CANBUS 55W resistor
On-board computer lighting error
If the on-board computer reports an error when the vehicle is switched on,
is caused by installation of low power consumers,
since the consumption e.g. was reduced from 55W to 20W.
Resistance control - equalizes voltage and corrects errors in on-board computer.
Only for vehicles with light test (lamp control) by on-board computer.
You just close resistance, and the mistake is gone.
There is no rating or review available.